
Page 2 of 4 GFI.doc, Rev.A, Created by E Smolentseva, 10/22/03
Tel: (800) 404-0204
www.ironwoodelectronics.com
Socket Base
Target PCB with SMT pads
Socket
Top Assembly
Compression Screw
Compression plate
BGA Package
Angle wire elastomer
Socket Lid
Round head Screw
Dowel pin
Socket Base Assembly
Backing Plate
(not necessary for
some sockets)
Hex Nut
Nylon Washer
IC Frame
Insulation Plate
(not necessary for
some sockets)
Figure 1: Graphical Illustration of Socket Assembly
Torque tool:
A torque tool should be used to apply the proper torque to the compression screw. There are
adjustable and factory preset torque tools currently available, which may be purchased
separately.
• TL-TORQUEDRIVER-01 (adjustable, 1.25-6.25 inch lb range)
• TL-TORQUEDRIVER-02 (adjustable, 3-15 inch lb range)
Comentarios a estos manuales